Paint Spraying Step by Step Guide      Back to Spraying & Painting 

	Hoses		Filters & Water Traps
	Regulators		Connectors

When deciding on the type of hose, filtration and connections the location of the compressor, safety, quality of air and speed of connecting equipment need to be taken into consideration.


Hoses

There are different types of hoses available for compressed air.

Always make sure that the hose has a rating which is equal to or higher than the maximum pressure of the compressor. Standard compressed air hoses are usually rated at 10 Bar. Find Out More

A simple 10m coil hose or flexible rubber hose would be ideal for use with a small direct drive compressor when operating a spray gun for fence panels, decking etc. Longer hoses would be required when undertaking spray tasks using a larger compressor as the compressor cannot always be located close to the spray area.


Regulators

A regulator is fitted as standard on a portable compressors and available as an optional on larger units. This will enable the pressure of the compressed air to be adjusted in line with recommended pressure of the particular spray gun or air tool being used. Find Out More


Filters & Water Traps

Extra filtration to remove oil and water can be added to the system when better quality of air is required such as car panel spraying or professional finishes. When purchasing a small oil free unit the oil content is nil and the standard regulator is suitable for spraying most domestic materials such as fence guard, emulsions, deck seals, etc.


Connectors

Quick connector couplings are a very useful addition to any compressed air system as it allows for the speedy and safe changing of air tools. It will stop the air escaping when the hose is disconnected.

For example, changing from an air blow gun (dusting of spray surface) to the spray gun is achieved in seconds, safely. Find Out More